Design These audio matchers use high quality low noise components to deliver broadcast and recording quality sound. Mathematically designed and tri-filar wound to produce a turns ratio of 1:1:1 for line level signals.
Primary (Input)/Secondary (Output) The transformer has three identical windings.
Magnet Wire All units are wound with the finest virgin copper magnet wire. All windings use heavy insulated wire to provide excellent manufacturing yield, lower customer cost and superior life.
The Core EDCOR uses the finest M6 line grain oriented steel cores. Each unit is hand stacked to assure at least 92% stack.
The Bobbin Injection molded Nylon 6/6 with the addition of 30%-35% glass fibers. The addition of glass fibers allows a higher heat deflection temperature and it brings the material to a class HB UL temperature classification.
Termination/Mounting This unit is designed for mounting on a printed circuit board. For footprint and suggested hole and pad size, see dimensional drawing.
Specifications
Wattage 0.5W Input Maximum Voltage 20Vrms Input Balanced or Unbalanced Primary (input) Impedance Depends on model. Output Balanced or Unbalanced Secondary (output) Impedance Depends on model. Turns Ratio Depends on model. Winding Configuration Tri-Filar Winding Frequency Response 20~20K Hz., <1dBu THD+Noise <0.05% @ 1K Hz. Frequency Response/THD+Noise Plot PCW150/150/150 Insertion Loss <0.5 dB Bobbin Material Nylon 6/6 GF-30 Flammability Rating Class HB Coil Finish Wrapping Polyester Film Electrical Insulating Tape Core Size EI63 (0.625" x 0.5") Core Material M-6 29 ga. grain oriented lamination steel Secondary Insulation Clear air dry polyester varnish Termination 12 pin PCB Mounting Printed circuit board (PCB) Mounting Orientation Laydown Weight 0.4 lbs. Compliance RoHS & REACH Dimensional Drawing 15000-EI625-050-P12 3D Model (STEP) 15000-EI625-050-P12
There are no reviews yet.
Please see our Privacy Policy
